# # Set the address and IRQ here. The ne.c and 3c503 driver will autoprobe # if you set the address or IRQ to zero, so we do that by default. # Cards supportted: # # WD80x3 The Western Digital (SMC) WD80x3 driver # WD_SHMEM=xxx Forces the address of the shared memory # FORCE_8BIT Force card into 8-bit mode (WD8003) # NE2000 The Novell NE-2000 driver # HPLAN The HP-LAN driver # EL1 The 3c501 EtherLink I driver (source missing?) # EL2 The 3c503 EtherLink II driver # EL2_AUI Selects the AUI port instead of the BNC port # PLIP The Crynwe PL/IP driver # SLIP The MicroWalt SLIP driver # SL_DUMP Uses the "dump frame" debug code # SL_COMPRESSED Use CSLIP # D_LINK The D-Link DE-600 Portable Ethernet Adaptor. # D_LINK_IO The D-Link I/O address (0x378 == default) # D_LINK_IRQ The D-Link IRQ number to use (IRQ7 == default) # D_LINK_DEBUG Enable or disable D-Link debugging # # Note: for most WD (SMC) cards, the AutoProbe doesn't work. You have # to force those cards into operation, by specifying the I/O add- # ress (EI8390=xxx), the IRQ (EI8390_IRQ=xxx) and the address of # the shared memory (WD_SHMEM=xxxx). All other supported cards # behave like they should, you can leave the values to 0. -FvK # # Comment out the lines you don't want.. #CARDS := $(CARDS) -DSLIP #CARDS := $(CARDS) -DPLIP CARDS := $(CARDS) -DWD80x3 CARDS := $(CARDS) -DNE2000 CARDS := $(CARDS) -DHPLAN CARDS := $(CARDS) -DEL2 CARDS := $(CARDS) -DD_LINK CARDS := $(CARDS) -DCONFIG_AT1500 # For WD and SMC cards: #OPTS = -DEI8390=0x280 -DEI8390_IRQ=15 #WD_OPTS = -DWD_SHMEM=0xCC000 -UFORCE_8BIT OPTS = -DEI8390=0 -DEI8390_IRQ=0 WD_OPTS = -DWD_SHMEM=0 # For all other cards: #OPTS = -DEI8390=0 -DEI8390_IRQ=0 #WD_OPTS = -DUD_SHMEM=0xCC000 -UFORCE_8BIT EL2_OPTS = #-UEL2_AUI NE_OPTS = HP_OPTS = PLIP_OPTS = SLIP_OPTS = -DSL_DUMP -DSL_COMPRESSED DL_OPTS = -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG AT_OPTS = # -DLANCE_DMA=5