root/drivers/net/CONFIG

/* [previous][next][first][last][top][bottom][index][help] */
#
# This file is used for selecting non-standard netcard options, and
# need not be modified for typical use.
#
# Drivers are *not* selected in this file, but rather with files
# automatically generated during the top-level kernel configuration.
#
# Special options supported, indexed by their 'config' name:
#
#  CONFIG_WD80x3        The Western Digital (SMC) WD80x3 driver
#       WD_SHMEM=xxx    Forces the address of the shared memory
#       WD_no_mapout    Don't map out the shared memory (faster, but
#                       your machine may not warm-boot).
#  CONFIG_NE2000        The NE-[12]000 clone driver.
#       PACKETBUF_MEMSIZE  Allows an extra-large packet buffer to be
#                       used.  Usually pointless under Linux.
#       show_all_SAPROM  Show the entire address PROM, not just the
#                       ethernet address, during boot.
#       rw_bugfix       Patch an obscure bug with a version of the 8390.
#  CONFIG_HPLAN         The HP-LAN driver (for 8390-based boards only).
#       rw_bugfix       Fix the same obscure bug.
#  CONFIG_EL2           The 3c503 EtherLink II driver
#       EL2_AUI         Default to the AUI port instead of the BNC port
#       no_probe_nonshared_memory  Don't probe for programmed-I/O boards.
#       EL2MEMTEST      Test shared memory at boot-time.
#  CONFIG_PLIP          The Crynwr-protocol PL/IP driver
#       INITIALTIMEOUTFACTOR    Timing parameters.
#       MAXTIMEOUTFACTOR
#  D_LINK               The D-Link DE-600 Portable Ethernet Adaptor.
#         D_LINK_IO     The D-Link I/O address (0x378 == typical)
#         D_LINK_IRQ    The D-Link IRQ number to use (IRQ7 == typical)
#         D_LINK_DEBUG  Enable or disable D-Link debugging
#  DEPCA                The DIGITAL series of AT Ethernet Cards (DE100, DE200)
#         DEPCA_IRQ     Set the desired IRQ (=0, for autoprobe)
#         DEPCA_DEBUG   Set the desired debug level
#

# The following options exist, but cannot be set in this file.
#  lance.c
#       LANCE_DMA       Change the default DMA to other than DMA5.
#  8390.c
#       NO_PINGPONG     Disable ping-pong transmit buffers.


# Most drivers also have a *_DEBUG setting that may be adjusted.
# The 8390 drivers share the EI_DEBUG settting.

# General options for Space.c
OPTS            = # -DETH0_ADDR=0x300 -DETH0_IRQ=11

WD_OPTS         = #-DWD_SHMEM=0xDD000
EL2_OPTS        = #-DEL2_AUI
NE_OPTS         =
HP_OPTS         =
PLIP_OPTS       =
DEPCA_OPTS      = -DDEPCA_IRQ=0 -DDEPCA_DEBUG=1

# The following are the only parameters that must be set in this file.
DL_OPTS         = -DD_LINK_IO=0x378 -DD_LINK_IRQ=7 -UD_LINK_DEBUG

/* [previous][next][first][last][top][bottom][index][help] */