root/arch/sparc/config.in

/* */

#
# arch/sparc/config.in
#
# Bare minimum configuration file for the Sparc.
#
# Copyright (C) 1994 David S. Miller (davem@caip.rutgers.edu)
#
# For a description of the syntax of this configuration file,
# see the Configure script.
#

echo "#define CONFIG_SPARCDEVS 1" >> $CONFIG_H
echo "CONFIG_SPARCDEVS=y" >> $CONFIG

comment 'Sparc Kernel setup'

bool 'Sun floppy controller support' CONFIG_BLK_DEV_SUNFD n
bool 'Networking support' CONFIG_NET n
bool 'Limit memory to low 16MB' CONFIG_MAX_16M n
bool 'System V IPC' CONFIG_SYSVIPC y
bool 'Kernel support for ELF binaries' CONFIG_BINFMT_ELF y

if [ "$CONFIG_NET" = "y" ]; then
comment 'Networking options'
bool 'TCP/IP networking' CONFIG_INET y
if [ "$CONFIG_INET" "=" "y" ]; then
bool 'IP forwarding/gatewaying' CONFIG_IP_FORWARD n
bool 'IP multicasting (ALPHA)' CONFIG_IP_MULTICAST n
bool 'IP firewalling' CONFIG_IP_FIREWALL n
bool 'IP accounting' CONFIG_IP_ACCT n
comment '(it is safe to leave these untouched)'
bool 'PC/TCP compatibility mode' CONFIG_INET_PCTCP n
bool 'Reverse ARP' CONFIG_INET_RARP n
bool 'Assume subnets are local' CONFIG_INET_SNARL y
bool 'Disable NAGLE algorithm (normally enabled)' CONFIG_TCP_NAGLE_OFF n
fi
bool 'The IPX protocol' CONFIG_IPX n
#bool 'Amateur Radio AX.25 Level 2' CONFIG_AX25 n
fi

comment 'SCSI support'

bool 'SCSI support?' CONFIG_SCSI n

if [ "$CONFIG_SCSI" = "n" ]; then

comment 'Skipping SCSI configuration options...'

else

comment 'SCSI support type (disk, tape, CDrom)'

bool 'SCSI disk support' CONFIG_BLK_DEV_SD y
bool 'SCSI tape support' CONFIG_CHR_DEV_ST n
bool 'SCSI CDROM support' CONFIG_BLK_DEV_SR n
bool 'SCSI generic support' CONFIG_CHR_DEV_SG n

comment 'SCSI low-level drivers'

bool 'Sun ESP Scsi support' CONFIG_SCSI_SUN_ESP n

fi


if [ "$CONFIG_NET" = "y" ]; then

comment 'Network device support'

bool 'Network device support?' CONFIG_NETDEVICES y
if [ "$CONFIG_NETDEVICES" = "n" ]; then

comment 'Skipping network driver configuration options...'

else
bool 'Dummy net driver support' CONFIG_DUMMY n
bool 'SLIP (serial line) support' CONFIG_SLIP n
if [ "$CONFIG_SLIP" = "y" ]; then
  bool ' CSLIP compressed headers' SL_COMPRESSED y
  bool ' 16 channels instead of 4' SL_SLIP_LOTS n
#  bool ' SLIP debugging on' SL_DUMP y
fi
bool 'PPP (point-to-point) support' CONFIG_PPP n
bool 'PLIP (parallel port) support' CONFIG_PLIP n
bool 'Load balancing support (experimental)' CONFIG_SLAVE_BALANCING n
bool 'Sun LANCE Ethernet support' CONFIG_SUN_LANCE n
bool 'Sun Intel Ethernet support' CONFIG_SUN_INTEL n
fi
fi

comment 'Filesystems'

bool 'Standard (minix) fs support' CONFIG_MINIX_FS n
bool 'Extended fs support' CONFIG_EXT_FS n
bool 'Second extended fs support' CONFIG_EXT2_FS y
bool 'xiafs filesystem support' CONFIG_XIA_FS n
bool 'msdos fs support' CONFIG_MSDOS_FS n
bool '/proc filesystem support' CONFIG_PROC_FS n
if [ "$CONFIG_INET" = "y" ]; then
bool 'NFS filesystem support' CONFIG_NFS_FS n
fi
if [ "$CONFIG_BLK_DEV_SR" = "y" -o "$CONFIG_CDU31A" = "y" -o "$CONFIG_MCD" = "y" -o "$CONFIG_SBPCD" = "y" -o "$CONFIG_BLK_DEV_IDECD" = "y" ]; then
        bool 'ISO9660 cdrom filesystem support' CONFIG_ISO9660_FS n
else
        bool 'ISO9660 cdrom filesystem support' CONFIG_ISO9660_FS n
fi
bool 'OS/2 HPFS filesystem support (read only)' CONFIG_HPFS_FS n
bool 'System V and Coherent filesystem support' CONFIG_SYSV_FS n


comment 'character devices'

bool 'Zilog serial support' CONFIG_SUN_ZS n

comment 'Sound'

bool 'Sun Audio support' CONFIG_SUN_AUDIO n

comment 'Kernel hacking'

bool 'Debug kmalloc/kfree' CONFIG_DEBUG_MALLOC n
bool 'Kernel profiling support' CONFIG_PROFILE n
if [ "$CONFIG_PROFILE" = "y" ]; then
  int ' Profile shift count' CONFIG_PROFILE_SHIFT 2
fi
if [ "$CONFIG_SCSI" = "y" ]; then
bool 'Verbose SCSI error reporting (kernel size +=12K)' CONFIG_SCSI_CONSTANTS y
fi

/* */