# # For a description of the syntax of this configuration file, # see the Configure script. # mainmenu_name "Linux Kernel Configuration" mainmenu_option next_comment comment 'General setup' bool 'Kernel math emulation' CONFIG_MATH_EMULATION bool 'Networking support' CONFIG_NET bool 'Limit memory to low 16MB' CONFIG_MAX_16M bool 'PCI bios support' CONFIG_PCI if [ "$CONFIG_PCI" = "y" ]; then bool ' PCI bridge optimisation (experimental)' CONFIG_PCI_OPTIMIZE fi bool 'System V IPC' CONFIG_SYSVIPC tristate 'Kernel support for ELF binaries' CONFIG_BINFMT_ELF if [ "$CONFIG_BINFMT_ELF" = "y" ]; then bool 'Compile kernel as ELF - if your GCC is ELF-GCC' CONFIG_KERNEL_ELF fi #bool 'Use -mpentium flag for Pentium-specific optimizations' CONFIG_M586 #if [ "$CONFIG_M586" = "n" ]; then bool 'Use -m486 flag for 486-specific optimizations' CONFIG_M486 #fi bool 'SMP Kernel (experimental - gcc2.5.8 only: see Documentation/SMP.txt)' CONFIG_SMP mainmenu_option next_comment comment 'Loadable module support' bool 'Set version information on all symbols for modules' CONFIG_MODVERSIONS source drivers/block/Config.in if [ "$CONFIG_NET" = "y" ]; then source net/Config.in fi mainmenu_option next_comment comment 'SCSI support' tristate 'SCSI support' CONFIG_SCSI if [ "$CONFIG_SCSI" != "n" ]; then source drivers/scsi/Config.in fi if [ "$CONFIG_NET" = "y" ]; then mainmenu_option next_comment comment 'Network device support' bool 'Network device support' CONFIG_NETDEVICES if [ "$CONFIG_NETDEVICES" = "y" ]; then source drivers/net/Config.in fi fi mainmenu_option next_comment comment 'CD-ROM drivers (not for SCSI or IDE/ATAPI drives)' bool 'Support non-SCSI/IDE/ATAPI drives' CONFIG_CD_NO_IDESCSI if [ "$CONFIG_CD_NO_IDESCSI" != "n" ]; then source drivers/cdrom/Config.in fi source fs/Config.in source drivers/char/Config.in mainmenu_option next_comment comment 'Sound' tristate 'Sound card support' CONFIG_SOUND if [ "$CONFIG_SOUND" != "n" ]; then source drivers/sound/Config.in fi mainmenu_option next_comment comment 'Kernel hacking' #bool 'Debug kmalloc/kfree' CONFIG_DEBUG_MALLOC bool 'Kernel profiling support' CONFIG_PROFILE if [ "$CONFIG_PROFILE" = "y" ]; then int ' Profile shift count' CONFIG_PROFILE_SHIFT 2 fi