root/arch/i386/config.in

/* */

#
# For a description of the syntax of this configuration file,
# see the Configure script.
#
mainmenu_name "Linux Kernel Configuration"

mainmenu_option next_comment
comment 'Loadable module support'
bool 'Enable loadable module support' CONFIG_MODULES
if [ "$CONFIG_MODULES" = "y" ]; then
  MODULES=y
  bool 'Set version information on all symbols for modules' CONFIG_MODVERSIONS
fi

mainmenu_option next_comment
comment 'General setup'

bool 'Kernel math emulation' CONFIG_MATH_EMULATION
bool 'Networking support' CONFIG_NET
bool 'Limit memory to low 16MB' CONFIG_MAX_16M
bool 'PCI bios support' CONFIG_PCI
if [ "$CONFIG_PCI" = "y" ]; then
  bool '   PCI bridge optimisation (experimental)' CONFIG_PCI_OPTIMIZE
fi
bool 'System V IPC' CONFIG_SYSVIPC
tristate 'Kernel support for ELF binaries' CONFIG_BINFMT_ELF
if [ "$CONFIG_BINFMT_ELF" = "y" ]; then
  bool 'Compile kernel as ELF - if your GCC is ELF-GCC' CONFIG_KERNEL_ELF
fi
choice 'Processor type' \
        "386            CONFIG_M386     \
         486            CONFIG_M486     \
         Pentium        CONFIG_M586" Pentium

source drivers/block/Config.in

if [ "$CONFIG_NET" = "y" ]; then
  source net/Config.in
fi

mainmenu_option next_comment
comment 'SCSI support'

tristate 'SCSI support' CONFIG_SCSI

if [ "$CONFIG_SCSI" != "n" ]; then
  source drivers/scsi/Config.in
fi

if [ "$CONFIG_NET" = "y" ]; then
  mainmenu_option next_comment
  comment 'Network device support'

  bool 'Network device support' CONFIG_NETDEVICES
  if [ "$CONFIG_NETDEVICES" = "y" ]; then
    source drivers/net/Config.in
  fi
fi

mainmenu_option next_comment
comment 'CD-ROM drivers (not for SCSI or IDE/ATAPI drives)'

bool 'Support non-SCSI/IDE/ATAPI CDROM drives' CONFIG_CD_NO_IDESCSI
if [ "$CONFIG_CD_NO_IDESCSI" != "n" ]; then
  source drivers/cdrom/Config.in
fi

source fs/Config.in

source drivers/char/Config.in

mainmenu_option next_comment
comment 'Sound'

tristate 'Sound card support' CONFIG_SOUND
if [ "$CONFIG_SOUND" != "n" ]; then
  source drivers/sound/Config.in
fi

mainmenu_option next_comment
comment 'Kernel hacking'

#bool 'Debug kmalloc/kfree' CONFIG_DEBUG_MALLOC
bool 'Kernel profiling support' CONFIG_PROFILE
if [ "$CONFIG_PROFILE" = "y" ]; then
  int ' Profile shift count' CONFIG_PROFILE_SHIFT 2
fi

/* */