root/drivers/block/Config.in

/* */

#
# Block device driver configuration
#
mainmenu_option next_comment
comment 'Floppy, IDE, and other block devices'

tristate 'Normal floppy disk support' CONFIG_BLK_DEV_FD
bool 'Enhanced IDE/MFM/RLL disk/cdrom/tape support' CONFIG_BLK_DEV_IDE
comment 'Please see drivers/block/README.ide for help/info on IDE drives'
if [ "$CONFIG_BLK_DEV_IDE" = "n" ]; then
  bool 'Old harddisk (MFM/RLL/IDE) driver' CONFIG_BLK_DEV_HD_ONLY
else
  bool '   Use old disk-only driver on primary interface' CONFIG_BLK_DEV_HD_IDE
  bool '   Include IDE/ATAPI CDROM support' CONFIG_BLK_DEV_IDECD
  bool '   Include IDE/ATAPI TAPE support' CONFIG_BLK_DEV_IDETAPE
  bool '   Support removable IDE interfaces (PCMCIA)' CONFIG_BLK_DEV_IDE_PCMCIA
  bool '   CMD640 chipset bugfix/support' CONFIG_BLK_DEV_CMD640
  if [ "$CONFIG_PCI" = "y" ]; then
    bool '   RZ1000 chipset bugfix/support' CONFIG_BLK_DEV_RZ1000
    bool '   Intel 430FX (Triton) chipset DMA support' CONFIG_BLK_DEV_TRITON
  fi
  bool '   Other IDE chipset support' CONFIG_IDE_CHIPSETS
  if [ "$CONFIG_IDE_CHIPSETS" = "y" ]; then
    comment 'Note: most of these also require special kernel boot parameters'
    bool '      DTC-2278        support' CONFIG_BLK_DEV_DTC2278
    bool '      Holtek HT6560B  support' CONFIG_BLK_DEV_HT6560B
    bool '      QDI QD6580      support' CONFIG_BLK_DEV_QD6580
    bool '      UMC 8672        support' CONFIG_BLK_DEV_UMC8672
    bool '      ALI M1439/M1445 support' CONFIG_BLK_DEV_ALI14XX
    bool '      PROMISE DC4030  support (ALPHA)' CONFIG_BLK_DEV_PROMISE
  fi
fi

tristate 'RAM disk support' CONFIG_BLK_DEV_RAM
if [ "$CONFIG_BLK_DEV_RAM" = "y" ]; then
  bool '   Initial RAM disk (initrd) support' CONFIG_BLK_DEV_INITRD
fi

tristate 'Loopback device support' CONFIG_BLK_DEV_LOOP

if [ "$CONFIG_BLK_DEV_HD_IDE" = "y" -o "$CONFIG_BLK_DEV_HD_ONLY" = "y" ]; then
  define_bool CONFIG_BLK_DEV_HD y
fi

tristate 'XT harddisk support' CONFIG_BLK_DEV_XD
bool 'Multiple devices driver support' CONFIG_BLK_DEV_MD
if [ "$CONFIG_BLK_DEV_MD" = "y" ]; then
  tristate '   Linear (append) mode' CONFIG_MD_LINEAR
  tristate '   RAID-0 (striping) mode' CONFIG_MD_STRIPED
fi
endmenu

/* */